BH FITNESS S3Ti Owner's Manual download pdf (Page 17)

To adjust the running belt, stop the treadmill,

then use the Hex Wrench and adjust the Hex

Screw located in the Rear End Cap. If the running

belt is moving towards the left side, tighten the

left Hex Screw about 1/4 turn (clockwise); if the

running belt is moving towards the right side,

tighten the right Hex Screw about 1/4 turn

(clockwise); Turn the treadmill on after it has

been adjusted. If you nd that the belt has not

moved to the proper position, please repeat the

steps above. Don’t use the treadmill until the

running belt returns to the center position.

e position of running belt might not stay

precisely in the center, it can and will shift

slightly towards the left and right sides, however,

you do not need to adjust the belt if it is not

rubbing against the side rails.

Depending on the usage of the product, please

apply silicon according to the chart to the right.

Use the Hex Wrench to unscrew the bolt inside

the Rear Roller. en pull the belt up and put

some silicon to the center of the board. After

that, adjust the belt to the center of the deck,

followed by tightening the screw to the original

set.

When the belt is sliding, please follow the above

method to lubricate the running board.

KGS/LBS Speed Interval

KGS

6KM/hr Below 1 year

6~12KM/hr 6 months

12KM/hr Above 3 months

LBS

4mile/hr Below 1 year

4~8mile/hr 6 months

8mile/hr Above 3 months

Note: This maintenance is intended for household

use. If used for business, it is suggested to

examine the product every other month.

Silicon Chart

BELT ADJUSTMENTS



1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 30 31

No comments

BH FITNESS S3Ti Owner's Manual Page 17